HYPER GO R30 Receiver for H16BM, H16DR, H14BM, H16PL

About this brushless motor

Where we can use one board across chassis, we do, and this is the widest of them: the sixteenth scale trucks and the fourteenth scale brushless car all take it. That makes it the useful spare to own if you run more than one of our cars, because a dead receiver on a Saturday is otherwise a week of waiting. Pair it after fitting and keep the aerial out of the loom.

Where it sits in the HYPER GO RC car range

The R30 is part of our Motors, ESCs & Radio Gear shelf, which carries 11 parts for the MJX HYPER GO range. Model code R30 is the number every listing here is keyed to: quote it and the gears, shocks, wheels and bodies that suit this chassis all line up. It is a service part rather than a vehicle, so check the fits row before you order.

Fit and compatibility

This part is listed against H16BM, H16DR, H14BM, H16PL. Those codes are stamped on the chassis plate under the body; photographs are a poor guide at this scale, because neighbouring versions differ by a couple of millimetres and look identical. If the plate on your car is unreadable, send us a picture with the shell off and we will tell you which version you have.

Living with it

Electronics fail hot. Blow the heatsink and the fans out after dusty sessions, keep the wires clear of the spur gear, and give the car two minutes between packs in summer.

Specification

Questions about the R30

Will this fit my HYPER GO RC car?

Match the model codes in the fits row above against the code stamped on your chassis plate. Brushed and brushless parts are not interchangeable in either direction.

Does it need setting up?

No. The 45A speed controls read the cell count when you plug a pack in and set their own cutoff. Receivers are bound with the transmitter held close to the car.

What if the car powers up but ignores the handset?

That is almost always a lost binding rather than a failed receiver. Rebind both units together before ordering a replacement.