Pit lane / Motors, ESCs & Radio Gear / E45P
HYPER GO E45P 45A Smart 2S/3S Brushless ESC
$34.99
In stock
5.0 out of 5 · 3 ratings
The smart forty five amp controller that reads the pack and sets its own cut off — two or three cells, no jumper to move.
Fits
- 14301
- 14302
- 14303
Model code E45P. Quote it when you order a spare — our part numbers are printed on the bag.
About this brushless motor
Getting the low voltage cut off wrong is how cells are killed, and on a shared truck it gets wrong often: someone drops a two cell pack into a car that was set for three. This board detects the cell count at power up and puts the cut off where it belongs, which takes that mistake off the table. It fits the 14301 family and its sister chassis, and it keeps the receiver separate.
Where it sits in the HYPER GO RC car range
The E45P is part of our Motors, ESCs & Radio Gear shelf, which carries 11 parts for the MJX HYPER GO range. Model code E45P is the number every listing here is keyed to: quote it and the gears, shocks, wheels and bodies that suit this chassis all line up. It is a service part rather than a vehicle, so check the fits row before you order.
Fit and compatibility
This part is listed against 14301, 14302, 14303. Those codes are stamped on the chassis plate under the body; photographs are a poor guide at this scale, because neighbouring versions differ by a couple of millimetres and look identical. If the plate on your car is unreadable, send us a picture with the shell off and we will tell you which version you have.
Living with it
Electronics fail hot. Blow the heatsink and the fans out after dusty sessions, keep the wires clear of the spur gear, and give the car two minutes between packs in summer.
Specification
| Part code | E45P |
|---|---|
| Continuous current | 45A |
| Type | Brushless, sensorless |
| Cell detection | Automatic, 2S or 3S |
| Receiver | Separate |
Questions about the E45P
- Will this fit my HYPER GO RC car?
- Match the model codes in the fits row above against the code stamped on your chassis plate. Brushed and brushless parts are not interchangeable in either direction.
- Does it need setting up?
- No. The 45A speed controls read the cell count when you plug a pack in and set their own cutoff. Receivers are bound with the transmitter held close to the car.
- What if the car powers up but ignores the handset?
- That is almost always a lost binding rather than a failed receiver. Rebind both units together before ordering a replacement.