HYPER GO 16431B Adjustable Tie Rod Linkages for H14BM

About this oil filled shock

Same idea as the sixteenth scale set, cut for the longer front end of the 1/14 truck: thread them in or out and the toe follows. On a car running at the speeds this one does, a hair of toe in at the front is worth more than it sounds — it stops the truck hunting on a rough straight. Match the two sides, then check the steering is centred at the servo and not at the link.

Where it sits in the HYPER GO RC car range

The 16431B is part of our Suspension, Shocks & Arms shelf, which carries 13 parts for the MJX HYPER GO range. Model code 16431B is the number every listing here is keyed to: quote it and the gears, shocks, wheels and bodies that suit this chassis all line up. It is a service part rather than a vehicle, so check the fits row before you order.

Fit and compatibility

This part is listed against H14BM. Those codes are stamped on the chassis plate under the body; photographs are a poor guide at this scale, because neighbouring versions differ by a couple of millimetres and look identical. If the plate on your car is unreadable, send us a picture with the shell off and we will tell you which version you have.

Living with it

Replace across an axle rather than one corner at a time. A fresh shock opposite a tired one makes a car that turns differently left and right, which is harder to drive than two tired shocks.

Specification

Questions about the 16431B

Which end of the car does this suit?

The fits row above lists the chassis and, where it matters, the end. Front and rear units on the 1/14 cars are different lengths.

Are these sold singly or in pairs?

As listed on the card. Shocks come in pairs so that an axle always gets matched damping; arms are sold both ways depending on the part.

My truck bounces after landings. Is this the fix?

If the shock body is wet with oil, yes. If the shaft is bent and the corner stays down, you need the unit rather than a rebuild.