HYPER GO 16410 Metal CVD Drive Shafts for H16PL and H16BM

About this spur gear

Two chassis in the sixteenth scale family use a shaft length of their own, and fitting the longer set to them binds the joint at full droop — which feels like a stiff diff and ends as a stripped cup. This is the pair for those two cars. Grease the cups on assembly and check the pins; a dry joint is noisy long before it is broken.

Where it sits in the HYPER GO RC car range

The 16410 is part of our Drivetrain, Gears & Axles shelf, which carries 6 parts for the MJX HYPER GO range. Model code 16410 is the number every listing here is keyed to: quote it and the gears, shocks, wheels and bodies that suit this chassis all line up. It is a service part rather than a vehicle, so check the fits row before you order.

Fit and compatibility

This part is listed against H16PL, H16BM. Those codes are stamped on the chassis plate under the body; photographs are a poor guide at this scale, because neighbouring versions differ by a couple of millimetres and look identical. If the plate on your car is unreadable, send us a picture with the shell off and we will tell you which version you have.

Living with it

Set gear mesh with a strip of paper between the teeth, tighten, then pull the paper out. Replace shafts in pairs across an axle so the car tracks straight under power.

Specification

Questions about the 16410

How do I know this is the right part?

Go by the model code on the chassis plate and the fits row above, not by the photograph. Drivetrain parts differ by a couple of millimetres and look identical in pictures.

Do I need to replace the pinion as well?

If you are replacing a worn spur, yes — they wear as a pair and a fresh gear against a worn pinion will whine and fail again quickly.

Is the differential serviceable?

It is supplied sealed and fitted as a unit. We do not sell the internal gears separately.